BASIC WORM BIN
Converts food scraps to wonderful Earthworm Castings
Design by Vermitech specialist Todd Spratt, Blue Belly Farm

PARTS NEEDED
30 gallon plastic storage container
8-2 inch square pieces of window screen
Top and cap from a typical water bottle
2 heavy duty nursery flats
12-1 inch screws or fence staples
3-1x3 wood stakes 3 ft. in length or like material

TOOLS NEEDED
Drill and 1 inch drill bit or hole saw
Hand or power saw
Screw driver and hammer
Glue gun or caulking with silicone
Scissors or tin snips and tape measure

The basic idea of this design is to create a raised interior floor so that moisture may drain away from the bedding collected and used to water plants, at the same time allowing air to circulate beneath the bedding.

BUILDING INSTRUCTIONS
Drill a one inch hole at one end of your storage container in the center and as near the bottom as possible. Using a saw or knife cut the top off the water bottle just below the rim. Unscrew the cap apply a bead of glue or caulk around the hole on the inside or the bin slip the bottle top through the hole from the inside and screw the cap back on, this will act as your drain. Note: you may have to enlarge the hole slightly with a knife or file so make sure the bottle top fits through the hole before applying glue. Now drill four 1 inch vent holes in each end of the bin 2 at the top and 2 at the bottom. Note: make sure the bottom vent holes are above the drain but below the raised floor. Apply glue around the vent holes on inside of bin a attach a 2 inch square piece of window screen over the holes. Cut the 1x3 raised floor supports the length of the inside of the bin place one on each side and one down the middle on edge, you may want four depending on the strength of your flats. Cut the flats with scissors or snips to fit the bottom of the bin they will overlap where they meet, then screw or staple the flats to the wood supports. You may also replace the flats with wire mesh or plywood with holes drilled in it. Add a layer of cardboard or paper over raised floor before adding bedding.

CLICK HERE FOR OPERATING INSTRUCTIONS FOR YOUR NEW WORM BIN.